Over on youtube, The 5th Volt has received an mm33 kit and shot a build video and a couple of audio demos — check it out!
The mm33 matrix mixer is designed to perform the mixing of audio or control signals without too many ‘bells and whistles’. Sometimes, however, it might be required that something different is needed, and that’s where this page comes in. We’re going to list a few things that you can change if you like — the intention is that this page might grow over time…Continue reading “mm33 mods…”
The initial run is nearly sold out now, so we are just considering updates to the design before sending out for a second run — many thanks to all of our customers so far!
You’ll all be glad to know that we just received some deliveries from our component suppliers and are able to start shifting the kits again. Pesky supply-chain!
Those of you who are on facebook and follow Tangible Waves might have seen their post a couple of days ago about a new module that we have been collaborating on — an oscilloscope!
We are proud to have been involved in writing the firmware for this device and can’t wait to get one in the rack!
The collaboration was sparked following a post on instagram of a tiny ‘scope that we were playing with. That might yet see the light of day (but obviously not in AEModular format) — we’ll see how it goes…
Exciting times! Check out Tangible Waves for more details as and when they appear…
After far too long (it seems), we have just released our first module for the AE Modular modular synthesiser system from Tangible Waves! It can now be seen alongside all of the other modules in the AE Modular Wiki.
The module is a 3×3 matrix mixer with buffered outputs, suitable for audio and control-signal mixing. We’ll put a video up on our YouTube channel at some point over the next few days showing it in use. The front panel can even be flipped over for a choice of look!
We thought that it was about time that we started a YouTube channel, where we can demo stuff etc. so here it is!
Until we’ve got 100 subscribers and been live for 30 days, the URL is a bit unwieldy, but hopefully we can get a few people on board…
The easiest way to subscribe is to watch the video in YouTube and click subscribe while you’re there!
We’ve just finished putting together the Rev.C version of the Core1 board – changes are:
- Smoother main output;
- Sub-oscillator output (square wave);
- Front panel!
Although the main output has been smoothed out, by mixing in the sub-oscillator a lot of the grit of the original versions can be regained, we believe this makes for a much more flexible and usable device.